Huawei USG6000 Series Hardware Manual page 294

HUAWEI USG6000 Series
Hardware Guide
l
To log in to the command configuration interface of the USG from the management PC, you
must configure the terminal emulation program on the PC. The following examples use the
Windows XP and Windows 7 operating systems.
l
l
Issue 08 (2017-06-30)
Cables and connectors are free of damage or breakage and are connected properly.
Windows XP
a. Start the HyperTerminal (Windows operating system) or other third-party program
that supports serial ports on the PC.
b. Create a connection, select the serial port, and configure the serial port parameters
as follows:
Bit per second: 9600
n
Data bit: 8
n
Parity: None
n
Stop bit: 1
n
Data flow control: None
n
c. Click OK. The copyright information is displayed on the HyperTerminal. You can
enter default user name admin and password Admin@123, modify the default
password as prompted to log in to the USG CLI.
Windows 7
Windows 7 does not include HyperTerminal like Windows XP did. However, you can
download a HyperTerminal program, such as PuTTY, for free from the Internet. PuTTY
is used as an example to describe the HyperTerminal configuration.
a. Download the PuTTY software to the local device and double-click it to run the
software.
b. Choose Session set the Connection type to Serial.
c. Set the PuTTY parameters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
280