Huawei USG6000 Series Hardware Manual page 337

HUAWEI USG6000 Series
Hardware Guide
Step 3 Remove the temporary labels on the cable and attach new labels 2 cm away from the
connectors.
----End
Follow-up Procedure
Perform the following checks after the installation:
l
l
To ensure that the PC can configure, manage, and maintain the USG through the mini USB
console port, install the mini USB drive program on the PC. You can log in to
support.huawei.com/enterprise, choose Downloads > Enterprise Networking > Security
> Firewall & VPN Gateway > USG6600, click the corresponding software version node, and
download MiniUSB_driver_en.zip to obtain the mini USB drive program and the installation
method.
NOTE
Before you plug in/out the USB cable or power on the USG again after you power it off, you must
disable the serial port communication software first. Otherwise, the PC may fail to load the mini USB
drive program, causing the serial port unavailable. If this fault occurs, you need to disable the serial port
communication software, re-plug in the USB cable, and enable the serial port communication software
again.
To log in to the USG CLI after the console cable is connected, configure the serial port
communication software on the PC. Windows XP and Windows 7 are used as examples.
l
Issue 08 (2017-06-30)
Figure 3-69 Connecting the console cable to the USG
STATUS
~100-240V;50/60Hz,5A
PAC-700WA-L
HDD0
SPUA
SPUB
Ensure that the labels attached to both ends of the cable are correct, clear, neat, and
affixed in the same direction.
Ensure that the cable and connectors are free of any damage or breakage and connected
properly and reliably.
Windows XP
a. Start the HyperTerminal (Windows operating system) or other third-party program
that supports serial ports on the PC.
b. Create a connection, select the serial port, and configure the serial port parameters
as follows:
Bit per second: 9600
n
Data bit: 8
n
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Mini USB
STATUS
PWR350A
HDD1
EN EN
0
RST
MGMT CONSOLE
3 Hardware Installation
FAN STATUS
9 PWR 10 PWR 13
F
~100-240V;50/60Hz,10A
11 SPU
A
12 SPU
N
SYS ALM MODE
RUN ALM
FAN
Console configuration cable
http://
USB
323