Huawei USG6000 Series Hardware Manual page 273

HUAWEI USG6000 Series
Hardware Guide
Context
l Do not install the antennas when the USG is powered on to prevent USG or antenna
l Do not mix the Wi-Fi and LTE antennas. The interface of the Wi-Fi antenna does not
l You are advised to place the LTE antenna at least 1.2 m away from the Wi-Fi antenna to
l The LTE antenna is quite long. You need to fasten it with cable ties during cabling.
Procedure
Step 1 Determine the interfaces for installing the antennas. The interfaces with the "WiFi 0" and
"WiFi 1" silkscreens on the rear panel are the interfaces for installing the Wi-Fi antenna, and
the interfaces with the "LTE MAIN" and LTE DIV" silkscreens are the interfaces for
installing the LTE antenna.
Step 2 Install the antennas.
1.
2.
3.
Issue 08 (2017-06-30)
NOTICE
damage.
match the LTE antenna, and the interface of the LTE antenna does not match the Wi-Fi
antenna. Therefore, you must insert them in the correct interfaces to prevent damages to
the antenna connectors.
prevent interference between signals.
NOTE
The Wi-Fi and LTE cable antennas are delivered with the USG.
Take off the protective cap of the antenna connector.
Install the antenna into the antenna connector of the USG.
Adjust the direction of the antenna. In different scenarios, the directions of the antennas
are different.
– When the USG is installed in a cabinet, the Wi-Fi antenna should be vertical to the
floor, and the LTE antenna should be placed outside the cabinet and be vertical to
the floor. For example, place the LTE antenna on the top of the cabinet.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
259