Huawei USG6000 Series Hardware Manual page 320

HUAWEI USG6000 Series
Hardware Guide
l
Procedure
l
l
Issue 08 (2017-06-30)
The power switch in the equipment room is easy to locate so that you can power off
devices in the case of accidents.
Power on the USG.
Turn on the switch of the power supply device and then the switch on the power module
of the USG. The USG starts.
You can identify the USG status based on indicators on the front and rear panels.
Indicators shown in Figure 3-54
Figure 3-54 Indicators when the
USG6306/6308/6330/6350/6360/6370/6380/6390/6390E/
6507/6530/6550/6570/6620/6630 runs normally
ALM: off
SYS: blinking green (once every two seconds)
PWR: steady green
Front view
SYS
SYS PWR MGMT
MGMT 0 1 2 3 4 5 6
Secospace USG6000
ALM
2
0/1 ALM HDD MODE
3
1
0
RST
CONSOLE
NPUT: steady green
Rear view
SM-HDD-SAS300G-B
Alarm indicator: off
SM-HDD-SAS300G-B
RUN indicator: blinking green
Power off the USG.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
indicate that the USG runs normally.
PWR MGMT
7 8 9 10 11
HDD MODE
OUTPUT: steady green
INPUT OUTPUT
ON
OFF ~100-240V;50/60Hz;2.5A
INPUT OUTPUT
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF ~100-240V;50/60Hz;2.5A
3 Hardware Installation
Secospace USG6000
4 HDD 5 PWR 6 PWR
306