Huawei USG6000 Series Hardware Manual page 330

HUAWEI USG6000 Series
Hardware Guide
Context
l Expansion cards are not hot-swappable. Do not power on the USG before you install any
l Before you hold expansion cards, make sure that you are wearing an ESD wrist strap and
Before installing the expansion card, complete the following steps:
l
l
l
Procedure
Step 1 Determine the slots for installing the expansion cards and note down the slot IDs. see the slot
numbering on the front panel of the USG.
Step 2 Based on the type of the expansion cards, install the cards as follows:
l
Issue 08 (2017-06-30)
NOTICE
expansion card.
that the strap is well grounded to protect the expansion cards.
Have the following instruments ready:
– Phillips screwdriver
– ESD wrist strap
Check the expansion card as follows:
– Check whether the expansion card models match the labels on the packing boxes.
– Check whether the expansion cards are damaged or have loose components.
If the expansion card models are not the same as that labeled on the packing boxes, the
card is damaged, or certain components are loosened, contact Huawei technical support
engineers.
Before you install an expansion card, check whether the USG supports this card. For
details on the hardware description of supported expansion cards, see Ports in Device
Overview.
Install the WSIC card, as shown in
a. Loose the bolts to remove the filler panel of the WSIC slot.
b. Open the lever and push the expansion card along the guide rail of the slot until the
lever touches the front panel of the slot.
c. Push the lever to insert the card into the slot. Then tighten the blots on both sides of
the card.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 3-65.
3 Hardware Installation
316