Huawei USG6000 Series Hardware Manual page 128

HUAWEI USG6000 Series
Hardware Guide
Name
MGMT port
Console port
(RJ45)
USB 2.0 port
0 to 3 (RJ45)
NOTE
4 to 5 (RJ45 +
SFP)
NOTE
Indicators
Issue 08 (2017-06-30)
Description
Out-of-band 10/100/1000M RJ45 autosensing Ethernet management
port. The interface number is GigabitEthernet 0/0/0 and the default IP
address of the interface is 192.168.0.1.
You can connect this port to the network port or any reachable port on a
PC through a network cable. Then, you can use Telnet to access the CLI
or use a web browser to access the web UI to configure, manage, and
maintain the USG.
NOTE
The MGMT port cannot be used as a service port.
Console ports allow you to locally connect a PC to the device. You can
use a console cable to connect the console port (RJ45) on the device to
the COM port on your PC and use a serial port terminal program on
your PC to access, configure, and manage the device.
l USB ports allow you to insert USB devices for system software
upgrades. For details on upgrades through USB devices, refer to the
Upgrade Guide delivered with the device.
l USB ports allow you to insert 4G LTE data cards. For details on the
4G LTE data cards, refer to
Service ports. They are four 10/100/1000M autosensing Ethernet
electrical ports numbered from GigabitEthernet 1/0/0 to
GigabitEthernet 1/0/3.
Arrowheads
show the
positions of
ports. A down
arrowhead
indicates a port
at the bottom,
and an up
arrowhead
indicates a port
at the top.
Combo ports. Combo ports are logic ports. One combo port can work as
a GE electrical interface or a GE optical port. Each combo port has only
one internal forwarding port. When the electrical port is enabled, the
optical port is disabled. When the optical port is enabled, the electrical
Arrowheads
port is disabled. The electrical and optical ports of a combo port use the
show the
positions of
same interface view, numbered from GigabitEthernet 1/0/4 to
ports. A down
GigabitEthernet 1/0/5. By default, the combo port is used as an electical
arrowhead
port. You can use the combo enable { copper | fiber } command to set
indicates a port
the working mode of combo ports according to network requirements.
at the bottom,
Each optical port supports a
and an up
arrowhead Optical
indicates a port
at the top.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2.6 4G LTE Data
Megabit Optical Transceiver
Transceiver.
2 Hardware Overview
Card.
or a Gigabit
114