Dell C9000 Series Reference Manual page 932

group interface
range
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
• For a null interface, enter the keyword null then the slot/
port information. The Null interface number is 0.
• For a Port Channel interface, enter the keyword port-
channel then the port-channel ID. Range is from 1 to
4096.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the
tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then the
slot/port information. The range is from 1 to 4094.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
(Optional) Enter the keyword group to configure an interface
group. You can create a interface group by adding a comma or
hyphen separate list of the following interface types:
• fortyGigE for a 40–Gigabit Ethernet interface.
• gigabitethernet for a GigabitEthernet interface.
• peGigE for a PE Gigabit Ethernet interface.
• TengigabitEthernet for a 10-Gigabit Ethernet interface.
• vlan for a VLAN interface.
(Optional) Enter the keyword range to configure an interface
range.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Interfaces 932