Ip Igmp Static-Group - Dell C9000 Series Reference Manual

Version
9.9(0.0)
Version 9.5(0.0)
Version 9.0.2.0
Version 8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in
the IGMP groups. You may not use extended access lists with this command. When you
configure a static SSM map and the router cannot find any matching access lists, the
router continues to accept (*,G) groups.
Related ip access-list standard
Commands

ip igmp static-group

Configure an IGMP static group.
C9000 Series
Syntax
ip igmp static-group {group address [exclude [source address]] |
[include {source address}]}
To delete a static address, use the no ip igmp static-group {group address
[exclude [source address]] | [include {source address}]} command.
Parameters
group address
exclude source
address
include source
address
Defaults none
Command Modes INTERFACE
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— creates a standard access list to filter based on IP address.
Enter the group address in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keyword exclude then the source
address, in dotted decimal format (A.B.C.D), for which a static
entry is added.
(OPTIONAL) Enter the keyword include then the source
address, in dotted decimal format (A.B.C.D), for which a static
entry is added.
Internet Group Management Protocol (IGMP) 1135