Match - Dell C9000 Series Reference Manual

Networking command-line reference guide
Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

Version
9.2(0.0)

match

Apply a match filter to the crypto policy.
C9000 Series
Syntax
match seq-num tcp [sourceip address | ipv6 address {mask} {source-
port number}] [destination ip address | ipv6 address {mask}
{destination-port number}]
To remove the match filter for the crypto map, use the no match seq-num tcp
[source ip address | ipv6 address {mask} {source-port number}]
[destination ip address | ipv6 address {mask} {destination-port
number}] command.
Parameters
seq-num
sourceip-address
| ipv6 address
mask
source-port
number
destination-port
number
Defaults
none
Command Modes
CONFIG-CRYPTO-POLICY
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.2(0.0)
Description
Introduced on the Z9000, S4810, and S4820T.
Enter the match command sequence number.
Enter the keyword source then the IPv4 or IPv6 address for the
source.
Enter the mask prefix length in /nn format.
Enter the source port number.
Enter the destination port number.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Internet Protocol Security (IPSec)
1159

Advertisement

Table of Contents
loading

Table of Contents