Show Ip Dhcp Snooping - Dell C9000 Series Reference Manual

show ip dhcp snooping

Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
C9000 Series
Syntax
show ip dhcp snooping [binding | source-address-validation
[discard—counter | interface interface]]
Parameters
binding
source-address-
validation
discard-counter
interface interface
Defaults none
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Display the interfaces configured with IP Source Guard.
Display the interfaces configured with IP Source Guard.
Display the drop count of the packets.
Enter the keyword interface then type one of the following
interface types and slot/port or number information:
•
•
•
•
•
• EXEC
• EXEC Privilege
Description
Introduced on the C9010.
Introduced on the Z9500.
For a 1–Gigabit Ethernet interface, enter the keyword
gigabitethernet.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
For a Port Channel interface, enter the keyword port-
channel then a number. Range is from 1 to 4096.
For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigabitEthernet then the pe-id, stack-
unit unit number, and port-id. The pe-id range is 0–255;
the stack unit number range is 0–7; and the port—ID range
is 0 –47.
Dynamic Host Configuration Protocol (DHCP) 836