Dell C9000 Series Reference Manual page 646

vman-dual-qos
number] ipv4pbr
numberopenflow
{4|8} | fcoe
number
[iscsioptacl
number] [vrfv4acl
number]
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
9.2(1.0)
9.2(0.2)
9.1.(0.0)
8.3.19.0
8.3.11.1
8.3.10.2
8.3.10.0
8.3.1.0
8.2.1.0
7.8.1.0
Usage Information Save the new CAM settings to the startup-config (write-mem or copy run start)
then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks;
these blocks cannot be reallocated. Only 12 number of blocks can be configured by the
user .
The fcoe range is 0–6 groups. Each group has 128 entries; the
value given must be an even number. This information is stored
in the NVRAM and is effective after rebooting the switch.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Added the nlbcluster ACL keyword. Introduced on the
S6000-ON.
Added support for PBR and VRF.
Introduced on the Z9500.
Added support for fcoe.
Added support for OpenFlow.
Introduced on the S4820T.
Introduced on the Z9000.
Clarified block information for the S4810.
Introduced on the S4810.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
Content Addressable Memory (CAM) 646