Show Lldp Neighbors - Dell C9000 Series Reference Manual

show lldp neighbors

Display LLDP neighbor information for all interfaces or a specified interface.
C9000 Series
Syntax
show lldp neighbors [interface] [detail]
From a PE console, use show lldp neighbors to view the LLDP neighbor information.
Parameters
interface
detail
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.1.(0.0)
8.3.19.0
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information..
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-unit
unit-number range is from 0 to 7; and the port-id range is
from 1 to 48.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
(OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and LLDP tx
and rx counters.
Description
Introduced on the C9010 and C1048P.
Introduced on the Z9500.
Modified output of detail parameter to display remote management
IP addresses.
Introduced on the S4820T.
Link Layer Discovery Protocol (LLDP) 1374