Dell C9000 Series Reference Manual page 522

Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information The following describes the show ip bgp flap command shown in the following
example.
Field
Network
From
Flaps
Duration
Reuse
Path
• ^ = (caret) the beginning of the input string. If you use the
caret at the beginning of a sequence or range, it matches
on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added the ipv4 multicast and ipv6 unicast parameters.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the network ID to which the route is flapping.
Displays the IP address of the neighbor advertising the flapping
route.
Displays the number of times the route flapped.
Displays the hours:minutes:seconds since the route first flapped.
Displays the hours:minutes:seconds until the flapped route is
available.
Lists all the ASs the flapping route passed through to reach the
destination network.
Border Gateway Protocol 522