Ip Domain-Lookup - Dell C9000 Series Reference Manual

If you configure both the ip domain-name and ip domain-list commands, the
software tries to resolve the name using the ip domain-name command. If the name
is not resolved, the software goes through the list of names configured with the ip
domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related ip domain-name
Commands

ip domain-lookup

Enable dynamic host-name to address resolution (that is, DNS).
C9000 Series
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
— specifies a DNS server.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
IPv4 Routing 1190