Ipv6 Control-Plane Icmp Error-Rate-Limit - Dell C9000 Series Reference Manual

Usage Information This command allows you to create an EUI64 address based on the specified prefix and
MAC address only. Prefixes may be configured on the interface using the ipv6 nd
prefix command without creating an EUI64 address.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-
limit
Configure the maximum number of ICMP error packets generated and sent in one second.
C9000 Series
Syntax

ipv6 control-plane icmp error-rate-limit {1-200}

To restore the default value, use the no ipv6 control-plane icmp error-rate-
limit command.
Parameters
pps
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Enter the maximum number of error packets generated per
second. The range is from 1 to 200.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
IPv6 Basics 1273