Debug Ip Bgp Keepalives - Dell C9000 Series Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information To remove all configured debug commands for BGP, enter the no debug ip bgp
command.

debug ip bgp keepalives

Display information about BGP keepalive messages.
C9000 Series
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] keepalives [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D |
X:X:X:X::X | peer-group peer-group-name] keepalives [in | out]
command.
Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group peer-
group-name
in
out
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to display BGP keepalive information corresponding to that
VRF.
(OPTIONAL) Enter the IPv4 address of the neighbor.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the keyword peer-group then the name of
the peer group.
(OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
(OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Border Gateway Protocol 452