Dell C9000 Series Reference Manual page 526

Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.8.0
8.3.7.0
7.8.1.0
7.7.1.0
7.5.1.0
7.2.1.0
6.3.10
Usage Information After a peer reset, the contents of the notification log messages is displayed in hex
values for debugging.
The neighbor information that this command displays does not include counts
corresponding to ignored prefixes and updates. However, the martian case is an
exception where neighbor information corresponding to ignored updates is displayed.
BGP shows the exact information that is exchanged between the BGP peers. It also
indicates whether or not this information is received by the BGP peer.
The following describes the show ip bgp neighbors command shown in the
following examples.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added the ipv4 multicast and ipv6 unicast parameters.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added the add-path option to the S4810. Output on the S4810
shows the ADDPATH parameters.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Added the detail option. Output now displays the default MED
value.
Added the received and denied route options.
The output is changed to display the total number of advertised
prefixes.
Border Gateway Protocol 526