Copying And Exchanging Parameter Settings - ABB i-bus KNX Product Manual


ABB i-bus KNX
Start-up
3.1.2

Copying and exchanging parameter settings

Parameterization of devices can take a lot of time depending on the complexity of the application and the
number of device inputs/outputs. To keep the commissioning work to the minimum possible, using the
function Copy/exchange channels, parameter settings of an input/output can be copied or exchanged with
freely selectable inputs/outputs. Optionally, the group addresses can be retained, copied or deleted in the
target input/output.
Note
When the term "channels" is used in ETS, it always means inputs and/or outputs. To make the
language of ETS generally valid for as many ABB i-bus
in this document.
The copy function for inputs/outputs is particularly useful with devices having the same parameter settings
for several outputs, inputs or groups. For example, lighting in a room is frequently controlled in an identical
manner. In this case, the parameter settings of input/output X can be copied to all other inputs/outputs or
to a special input/output of the device. Thus the parameters for this input/output need not be set
separately, which significantly shortens the commissioning time.
The exchange of parameter settings is useful, e.g. should the inputs/outputs be swapped when wiring the
terminals. The parameter settings of the incorrectly wired inputs/outputs can be simply exchanged saving
the requirement for time-consuming rewiring.
®
devices as possible, the word channels is used
JRA/S | 2CDC 506 051 D0204 35