ABB i-bus KNX Product Manual page 102


ABB i-bus KNX
Start-up
No.
13
This communication object is enabled if, in the parameter window A: Positions/presets, p.72, the parameter Enable
communication objects "Move to height/slat position [0...255]" was selected with option Yes.
If a telegram is received at this communication object, the blind/shutter is moved to the height corresponding to the received
value.
After the target position is reached, the slats will assume the same position which they had before the movement started. If a
telegram is received during movement at the communication object Move slats [0...255], then the slat are set according to
the received value after the target position has been reached.
Telegram value:
14
This communication object is enabled if, in the parameter window A: Positions/presets, p.72, the parameter Enable
communication objects "Move to height/slat position [0...255]" was selected with option Yes.
If a telegram is received at this communications object, the slats are then positioned in accordance with the received value. If
the blind/shutter is currently moving, the movement will continue to the target position and only then are the slats positioned.
Telegram value:
15
16
This communication object is enabled if, in the parameter window A: Positions/presets, p.72, the parameter Enable
communication objects "Move to/set positions 1-4" 1 bit was selected with option Yes.
If a telegram is received at this communication object, then the blind/shutter is moved to the saved preset position. In the
Control with slat adjustment operation mode, slat positioning is undertaken according to the saved preset value after the
position has been reached. If a telegram with the value 0 is received, the blind/shutter moves to the parameterized position 1
(or position 3). If a telegram with the value 1 is received, the blind/shutter moves to the parameterized position 2 (or position
4).
Telegram value:
17
18
This communication object is enabled if, in the parameter window A: Positions/presets, p.72, the parameter Enable
communication objects "Move to/set positions 1-4" 1 bit was selected with option Yes.
If a telegram is received at this communications object, then the current position of the blind/shutter is accepted as the new
preset value. If the telegram value 0 is received, then the current position is saved as the preset value for position 1 (or
position 3). If the telegram value 1 is received, then the current position is saved as the preset value for position 2 (or
position 4).
The changed preset values are retained on a bus voltage failure. When the device is reprogrammed, it is possible to set via a
parameter if the values parameterized in advance should be overwritten.
Telegram value:
100 2CDC 506 051 D0204 | JRA/S
Function
Move to pos. height [0...255]
0 = Upper
...
= Intermediate position
255 = Lower
Move slats [0...255]
Note
This communication object is only available in the Control with slat adjustment operation mode.
0 = OPEN slats
...
= Intermediate position
255 = CLOSE slats
Move to position 1, 2
Move to position 3, 4
0 = Move to position 1 or position 3
1 = Move to position 2 or position 4
Set position 1, 2
Set position 3, 4
0 = Set position 1 or position 3
1 = Set position 2 or set position 4
Object name
Output A
Output A
Output A
Output A
Data type Flags
1-byte C, W
DPT 5.001
1-byte C, W
DPT 5.001
1 bit C, W
DPT 1.002
1 bit C, W
DPT 1.002