ABB i-bus KNX Product Manual page 64


ABB i-bus KNX
Start-up
Pause on change in direct. in ms (see
technical data of drive!) 50...10,000
Options
This parameter defines the pause to change direction of the drive in milliseconds.
Caution
The technical data of the drive manufacturer must always be observed!
Delay times for drive
Options:
Some drives do not provide the full power immediately but only after a start-up delay of a few milliseconds.
Other drives continue to run on for a few milliseconds (coasting delay). For some applications, it may be
necessary to compensate delay times when starting and stopping the drive, e.g. blinds/shutters must be
positioned exactly.
Note
These parameters must only be entered if you require en even more exact positioning of the
blind/shutter. Generally, the basic parameters are adequate to ensure correct operation.

Standard: In this setting, the delay time (0 ms) cannot be changed.

User-defined: The following parameters appear:
62 2CDC 506 051 D0204 | JRA/S
50...500...10,000
:
Standard
User-defined
Diff. between start-up and coasting
delay: time in ms*4 [- 128...127]
Options: -128...0...127
This parameter defines the start-up and coasting delay times of the drive. The value to be entered
is calculated from the values of the drive. The value is calculated as follows:
(Start-up delay – Coasting delay) * 4 = Value
The value has to be an integer number and should be rounded up or down.
The value is indicated in milliseconds (ms).
The multiplication by 4 covers the value range from -512 ms to 508 ms in 4 ms steps ((-512 =
-128; -508 = -127; -504 = -126 ... -4 = -1 ; 0 = 0; 4 = 1; ... 500 = 125; 504 = 126; 508 = 127).
Caution
The technical data of the drive manufacturer must always be observed!
Minimum run time for drive
in ms [10...255]
10...50...255
:
Options
This parameter defines the minimum run time of the drive.
Caution
The technical data of the drive manufacturer must always be observed!