ABB i-bus KNX Product Manual page 87


ABB i-bus KNX
Start-up
Enable communication object
"Status Automatic" 1 bit
Options:
The output sends information on whether automatic control is activated or deactivated (1 bit).
This function is particularly suitable to indicate to the user via an LED if automatic control has been
activated.

Yes: The communication object Status Automatic is enabled. The following parameter appears:
Send object value
Options: No, update only
On change
On request
On change or on request

No, only update: The status is updated but not sent (the status can be read via the
communication object).

On change: The status is sent when a change occurs.

On request: The status is sent when a request occurs.

On change or on request: The status is sent on a change or a request.
Yes
No
Send object value
Options: No, update only
On change
On request
On change or on request

No, only update: The status is updated but not sent (the status can be read via the
communication object).

On change: The status is sent when a change occurs.

On request: The status is sent when a request occurs.

On change or on request: The status is sent on a change or a request.
JRA/S | 2CDC 506 051 D0204 85