Code Table For Communication Object Status Information (Bit 0 - ABB i-bus KNX Product Manual


ABB i-bus KNX
Appendix

Code table for communication object Status information (Bit 0...7)

A.3
The 2-byte communication object Status information makes information on the operating state of the
output and connected drives available. The communication object Status information can be sent to the
KNX via the inter-device communication object Request status values.
For further information, see: Communication object no. 39 ff and No. 1.
The communication object Status information is divided up into two 1-byte values:
Bit 0...7 = Low Byte
Bit 8...15 = High Byte
The Low Byte shows the operating states of the output. Only one operating state can ever be active (1 n)
In the High Byte, additional status information on the output is made available. Multiple items of
information may be active simultaneously.
Low Byte code table; Operation mode Control with slat adjustment
Bit no. 7
0 00
1 01
2 02
4 04
8 08
16 10
32 20
64 40
128 80
Othe Othe
r
Empty = Value 0

6 5 4 3 2 1







- - - - - - -
r
= Value 1, applicable
0
Current
status Operation
Direct positioning Via CO
- Up/down
- Stop/slat adj.
- Move to position
- Scene
Using the Up/Down

Manual operation
buttons
Block Disabled
Forced operation Disabled
Frost alarm Disabled
Rain alarm Disabled
Wind alarm Disabled
Automatic sun Via communication
protection objects:
– Sun
– Sun position
– Sun slat
Automatic Via communication
heating/cooling objects:
– Heating
– Cooling
-
Not defined
JRA/S | 2CDC 506 051 D0204 123