ABB i-bus KNX Product Manual page 78


ABB i-bus KNX
Start-up
Toggling to automatic control
Toggling to direct control
Options:
This parameter determines how the switchover to automatic control or direct control is enabled or whether
it should be enabled/disabled via an additional communication object.

Disable/enable via object: The communication objects Disable/enable autom. control and
Disable/enable direct control are enabled.
Position for sun = 1 (sun)
Position for sun = 0 (no sun)
Options:
1
Only in the operation mode Control with slat adjustment
2
Only in the operation mode Control without slat adjustment
These parameters are used to set the reaction for the communication object Sun = 1 (sun) or for the
communication object 0 (no sun) in automatic operation.
76 2CDC 506 051 D0204 | JRA/S
Automatic reactivation of
automatic control
Options: Deactivated
Activated
If automatic control was deactivated via one of the direct communication objects, it is possible to
reactivate automatic control automatically after a parameterized time.

Activated: The following parameter appears.
Time to reactivate autom. control
automatically in min. [10...6,000]
10...300...6.000
Options:
Note
A change of the parameter value will only become active after the next deactivation of
automatic control by a direct communication object.
Enabled
Disable/enable via object
No reaction
Up
Down
Stop
Position 1-4
Individual position
Receive position via object
Receive height and slat via object
Receive only slat via object
Receive position via object
Deactivated
1
1
2