Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
Transferring options to the new motherboard
After you verify that the new motherboard solves the problem that you are troubleshooting,
you must use the Fiery Options Utility DVD and the one-time use dongle to transfer options
to the new motherboard.
Once the options are transferred, the new motherboard is customized and cannot be used in
another system. If your new motherboard kit contains a CD other than the Fiery Options
Utility DVD, such as the Feature Update CD, do not use the procedure described in this section.
Instead, use the procedure described in the documentation that accompanies the
motherboard kit to update the system.
T
O TRANSFER OPTIONS TO THE NEW MOTHERBOARD
This procedure assumes that the imagePRESS Server is fully assembled, verified in
N
:
OTE
Service Mode (see
1. Make sure that the one-time use dongle is firmly attached to a USB port on the
imagePRESS Server and that no other dongles or USB storage devices (for example, a flash or
thumb drive) are attached to the imagePRESS Server.
The options transfer process may fail if other dongles and/or USB storage devices are
connected to the imagePRESS Server during the process. Reconnect other dongles and
devices after you complete the option transfer process.
2. Power on the imagePRESS Server.
3. Immediately insert the Fiery Options Utility DVD into the DVD drive.
N
:
The Fiery Options Utility DVD must be in the DVD drive in time for the
OTE
imagePRESS Server to boot from it. If the imagePRESS Server does not boot from the Fiery
Options Utility DVD, allow the imagePRESS Server to start up, eject the CD, turn off the
imagePRESS Server, and then repeat steps 2 and 3.
page
87), and powered off.
90
Advertisement
Table of Contents
