Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REPLACE THE POWER SUPPLY
1. Make sure that the imagePRESS Server is in the upright position.
2. Position the power supply inside the chassis (see
Place the power supply on top of the left and right chassis bars. Fit the ends of the support
beam over the chassis bars, and position the power supply so that it is flush against the back
panel.
3. Secure the support beam to the left and right chassis bars with the two screws you removed
earlier (see
Figure 41 on page
4. Install the four screws that secure the power supply to the back panel of the chassis.
5. Connect one of the SATA power cables to the power connector on the dual data/power cable
that connects to the DVD drive.
6. Connect three of the other SATA power cables to the SATA power connectors on the three
HDDs.
N
:
Some HDDs may have both PATA and SATA power connectors. Always connect
OTE
power to the SATA power connector on the HDD. Do not use the PATA power connector.
7. Install the ferrite around the three SATA power cables that connect to the HDDs.
Use the ferrite that you removed earlier. Place the ferrite around all three cables, and snap the
edges of the ferrite closed.
8. Connect the power cables to the motherboard (see
page
76):
• 8-pin power cables to connectors PW1 and PW3
You may connect either 8-pin cable to either power connector on the motherboard.
• 24-pin power cable to connector PW2
9. Replace the tie wraps that you removed earlier.
10. Reassemble the imagePRESS Server and verify its functionality (see
Figure 41 on page
116).
Figure 17 on page 58
117
116).
and
Figure 26 on
page
130).
Advertisement
Table of Contents
