Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
DVD
O REPLACE THE
DRIVE
1. Secure the DVD drive to the switch bank assembly using the four screws that you removed
earlier (see
Figure 47 on page
2. Install the switch bank assembly in the component sled, and then install the component sled
in the chassis (see
3. Connect the data/power cable to the dual connector on the back of the DVD drive.
Make sure that the other ends of the cable are connected to the power supply and to SATA0
on the motherboard.
4. Reassemble the imagePRESS Server and verify its functionality (see
128).
page
126).
129
page
130).
Advertisement
Table of Contents
