Table of Contents
Advertisement
S
ERVICE
Restoring and verifying functionality after service
Complete your inspection and service by reassembling and verifying the imagePRESS Server.
Do not lift the imagePRESS Server without assistance. Follow standard ESD precautions
when handling internal components (see
T
O REASSEMBLE AND VERIFY THE IMAGE
1. Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables in the imagePRESS Server make sure that:
• Covers are securely installed after routing cables
• Cables are not looped around internal circuit boards, or components (such as capacitors
and resistors)
• Cable routing does not interfere with the operation of internal components
• Cables do not lie on or against any internal heating element
• Cables do not interfere with removing or replacing components
• Cables do not interfere with opening or closing imagePRESS Server panels
• Cables are not tangled
• Cable slack is secured with tie wraps
2. Restore the system to the upright position.
3. Replace any panels that you removed earlier, as described in
imagePRESS Server" on page
4. If you installed a new HDD, install system software (see
Replacement HDDs are not shipped with pre-installed system software.
5. If you replaced the motherboard with a new motherboard, make sure that the new
motherboard solves the problem that you are troubleshooting (see
transfer options to the new motherboard (see
6. Make sure to configure the date and time in Setup (see Configuration and Setup on the User
Documentation CD).
7. Before you leave the customer site, verify the imagePRESS Server operation (see
P
ROCEDURES
PRESS S
ERVER
60.
page
17).
"Opening the
page
132).
page
90).
130
page
87), and then
Figure
48).
Advertisement
Table of Contents
