Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
4. Secure the UIB to the underside of the top panel (see
Hold the plastic lens in place as you position the UIB in the mounting area of the top panel.
Carefully fit the UIB buttons through the cutouts in the top panel.
Replace the four screws that secure the UIB to the underside of the top panel. Be sure to use
the same screws that you removed earlier.
5. If you are replacing the UIB cable with a new cable, do the following:
Cut the tie wrap securing the old cable to the underside of the top panel and remove the old
cable.
The tie wrap is used to secure the cable during shipment and does not need to be
N
:
OTE
replaced when you replace the cable.
6. Attach the UIB cable to the connector on the back of the UIB.
7. Replace the top panel (see
When replacing the top panel, be sure to route the UIB cable through the chassis and
N
:
OTE
connect it to the UIB connector (USB1) on the motherboard. For the location of the
motherboard connector, see
8. Reassemble the imagePRESS Server and verify its functionality (see
page
65).
Figure 16 on page 57
and
Figure 24 on page
72).
Figure 26 on page
76.
page
130).
74
Advertisement
Table of Contents
