Table of Contents
Advertisement
I
NSTALLATION
6. Verify that the cables are firmly connected to the copier and imagePRESS Server.
Make sure that the cable connectors are firmly locked into their respective ports on either end.
To verify that the cable connectors are locked in place, gently move each cable connector side
to side (not up and down).
N
:
To prevent risk of cross-talk, make sure the copier interface cables do not touch the
OTE
power cords for the system. Image quality problems or imagePRESS Server shutdowns could
result.
7. Locate the Command/Status (crossover Ethernet) cable that shipped with the
imagePRESS Server.
N
:
Be sure to use the crossover Ethernet cable for the Command/Status connection.
OTE
To verify the cable type, align the connectors on each end of the cable as shown in
on page
40. On a straight-through cable, the wire arrangements are identical on both ends; on
a crossover cable, the wire arrangements are different.
8. Connect the cable to the Command/Status connector on the back of the imagePRESS Server,
and to the Command/Status connector on the copier (see
9. Power on the imagePRESS Server (see
10. Power on the copier (for instructions, see the documentation that accompanies the copier).
Figure 8 on page
page
51).
39
Figure 9
38).
Advertisement
Table of Contents
