Table of Contents
Advertisement
S
S
YSTEM
OFTWARE
10. At the Control Panel message "User Software installation is complete. Remove CD/DVD.
System will reboot," remove System Software DVD2.
Allow the system to reboot automatically and reach Idle. When the system reaches Idle,
imagePRESS Server logo screen appears on the Control Panel.
If the Control Panel activity light flashes red, or the FieryBar on the optional monitor
N
:
OTE
flashes red and displays the message "Unable to detect video boards: Make sure video boards
are installed," reboot the system. If the error persists, reboot the system again.
11. Reinstall any required software patches:
• If you reinstalled the same version of system software, be sure to reinstall all software
patches that were previously installed on the Print Server. For a list of previously installed
patches, see the Configuration page that you printed earlier.
• If you installed an upgraded version of system software (for example, version 1.0 to version
2.0), contact your authorized service/support center for a list of valid software patches.
Some or all of the patches listed on the Configuration page that you printed earlier may no
longer be valid. Before installing a patch, be sure to verify with your authorized service/
support center that it is valid for your system version. Installing an invalid patch may result
in system corruption.
Software patches may be accessed from one or more of the following locations:
• System Updates—Using the keyboard (if present), choose Start > All Programs > Fiery >
System Updates, and then click Check Now.
• Check for Product Updates—In a Web browser, connect to the IP address of the Print
Server, click the Configure tab, and then click Check for Product Updates.
136
Advertisement
Table of Contents
