Figure 46: Removing/Replacing The Switch Bank Assembly - Canon imagePRESS A3200 Installation And Service Manual

S P
ERVICE ROCEDURES
5. Remove the switch bank assembly from the component sled (see
Remove the three screws that attach the switch bank assembly to the component sled. Pull the
switch bank assembly straight out of the component sled.
Guide the cables as you remove the switch bank assembly from the component sled.
N :
OTE
Be careful not to damage the EMI gasket lining the slot in the component sled.
Removing/replacing the switch bank assembly
F 46:
IGURE
6. If you are removing the switch bank assembly to replace it with a new assembly, remove the
DVD drive (see page
T
O REPLACE THE SWITCH BANK ASSEMBLY
1. If you are installing a replacement switch bank assembly, attach the extension cables for the
power and reset button cables.
Locate the two extension cables included in the replacement switch bank assembly kit. Attach
each extension cable to its corresponding base cable in the switch bank assembly, aligning the
arrow on the extension cable connector with the arrow on the base cable connector.
2. If it is not already attached, secure the DVD drive to the switch bank assembly
(see page 129).
3. Install the switch bank assembly in the component sled (see
• Starting with the cables, insert the switch bank assembly through the slot in the front of
the component sled. Be sure to fold the EMI gasket under and in through the slot when
inserting the assembly.
• Replace the three screws that secure the switch bank assembly to the component sled.
128).
Figure 46).
Slot with
gasket lining
Screw
(1 of 3)
Figure 46 on page 126).
126