Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
4. Install the component sled in the chassis (see
• Route the cables of the switch bank assembly in through the chassis so that the cables are
within reach of their connectors on the motherboard.
• Slide the component sled into the front of the chassis until the latches click into the place.
Be careful not the damage the EMI gasket around the slot in the chassis when installing the
component sled.
5. Connect the following cables (see
the motherboard):
• Data/power cable to the dual connector on the back of the DVD drive
• DVD data cable to motherboard connector SATA0
• Power button cable to motherboard connector J102, pins 6 and 8
Make sure that the triangle on the cable connector aligns with pin 6, as shown in
Figure 17 on page
• Reset button cable to motherboard connector J102, pins 5 and 7
Make sure that the triangle on the cable connector aligns with pin 7, as shown in
Figure 17 on page
• Speaker cable to motherboard connector J105
Make sure that the triangle on the cable connector aligns with the correct pin, as shown in
Figure 17 on page
• Front USB port cables to the USB2 and USB3 connectors on the motherboard (either
USB connector may be used for either cable)
6. Install the ferrite around the front USB port cables near the motherboard.
Use the ferrite that you removed earlier. Place the ferrite around both cables, in between the
two preinstalled tie wraps, and snap the edges of the ferrite closed.
7. Reassemble the imagePRESS Server and verify its functionality (see
Figure 45 on page
Figure 26 on page 76
58.
58.
58.
125).
for the location of each connector on
page
130).
127
Advertisement
Table of Contents
