Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
DIMM
O REPLACE A
1. Shut down the imagePRESS Server, remove all cables from the back, and open the system
(see
page
59).
In order to access the DIMMs, you must remove the left panel.
2. To release a DIMM, push outward on the levers on each side of the DIMM.
Lever
F
33:
Releasing a DIMM
IGURE
3. Lift the DIMM straight out of the socket.
4. To replace a DIMM, position the DIMM in the socket and press the DIMM straight down into
the socket so that the levers lock the DIMM into place.
DIMMs fit in the socket only one way. The notch on the bottom of each DIMM
N
:
OTE
should line up with the notch in the socket.
Make sure that the levers close securely around the ends of the DIMM and each DIMM is
fully seated in its socket.
5. If you installed a new or additional DIMM, clear the CMOS (see
You should clear the CMOS after installing a new or additional DIMM to ensure
compatibility between the new component and previous settings stored in the BIOS.
N
:
Be sure to remove the power cable from the imagePRESS Server before clearing the
OTE
CMOS.
• Remove the battery (see
• Wait two minutes to allow the motherboard electrical components to fully discharge.
• Reinstall the battery (see
6. Reassemble the imagePRESS Server and verify its functionality (see
7. If you installed a new DIMM and cleared the CMOS, configure the time and date in Setup.
For more information, see Configuration and Setup on the User Documentation CD.
DIMM
Socket notch
page
97).
page
97).
101
Lever
page
98).
page
130).
Advertisement
Table of Contents
