Samsung OfficeServ 7000 Series Programming Manual page 415

No Option
04 CTI LINK OPTION
05 ITP DSP PARA
06 ITP TX GAIN/HSET
Samsung Business Communications
Description
Sets CTI link via LAN option with the system.
0 SMDR REPORT: Sets YES or NO for SMDR data
to CTI link via LAN.
1 UCD REPORT: Sets YES or NO for UCD data to
CTI link via LAN.
2 ALIVE: This is a CTI link via LAN alive check
timer. If this is set to 0, the system will not
check link alive.
Sets IP phone DSP parameter system wide.
0 M-FRAME: This value determines the trans-
mission interval time of VoIP packets generated
by the IP phone. This data uses DOWN = SYS
DATA only(see 3, below). The range is
10~40 ms.
1 JITTER: Decides the minimum time to consider
delay for jitter adjustment. This data uses
DOWN = SYS DATA only(see 3, below). The
range is 10~90 ms.
2 TOS: An 8-bit binary value that will be used by
external routers, switches, etc,(that optionally
support TOS-bit prioritization) to identify the
transport-priority value of data packets gener-
ated by the IP phone. This value can be left at
the default value(00000) if your network infra-
structure does not support this method of
bandwidth management. This data uses DOWN
= SYSTEM DATA only(see 3, below).
3 CONTROL: Designate whether to set the DSP
parameter of the IP phone as the SYSTEM
BASE or as the ITP BASE.
4 CODEC: Designate whether to use the CODEC
based on the MGI or to use the CODEC of the
IP phone when connecting the call between the
IP phone and the MGI.
Sets IP-based phone Handset TX gain value of
each level.
CHAPTER 2. MMC Programming
(continued)
Default
NO
NO
300 SEC
10 ms
20 ms
All bits 0
SYS BASE
MGI FIRST
LEVEL 1: 25
LEVEL 2: 27
LEVEL 3: 29
LEVEL 4: 31
LEVEL 5: 33
LEVEL 6: 35
LEVEL 7: 37
LEVEL 8: 39
2-373