Cisco Catalyst 4500 Series Message Manual page 121

Chapter 2 Messages and Recovery Procedures
Error Message C4K_SUPERVISOR-3-NETFLOWCARDSEEPROMREADFAILED: Netflow Services Card
seeprom read failed
Explanation
Recommended Action
prompt.
Error Message C4K_SUPERVISOR-3-NETFLOWCARDSEEPROMUNKNOWNTYPE: Unknown Netflow
Services Card revision: Read fru major/minor ([hex],[hex]) but expected
([hex],[hex]).
Explanation
with this release of software. The card will be ignored.
Recommended Action
prompt.
Error Message C4K_SUPERVISOR-3-POWERSUPPLYSTATUSREADFAILED:Failed to read power
supply [dec]'s status register
Explanation
Recommended Action
power supply.
Error Message C4K_SUPERVISOR-3-POWERSUPPLYSEEPROMREADFAILED: Failed to read power
supply [dec]'s serial eeprom
Explanation
Recommended Action
with a new power supply.
Error Message C4K_SUPERVISOR-3-RETIMERDISABLEFAILED:Failed to disable the retimer of
the active supervisor's uplink.
Explanation
you might see packets that are transmitted out the active supervisor engine's nonactive uplink.
Recommended Action
Error Message C4K_SUPERVISOR-3-RETIMERINITFAILED:Failed to initialize the retimer of
the active supervisor's uplink.
Explanation
you might see packets that are transmitted out the active supervisor engine's nonactive uplink.
Recommended Action
OL-11541-01
A reading of the serial EEPROM on the NetFlow Services Card failed.
For more information, enter the sprom read nffc command at the ROMMON
The serial EEPROM on the NetFlow Services Card has a revision that is not compatible
For more information, enter the sprom read nffc command at the ROMMON
Reading the power supply status register failed.
Try reinserting the power supply. If the message persists, hot swap it with a new
A failure occurred while reading the power supply serial EEPROM.
Reinsert the power supply. If that does not work, replace the old power supply
The retimer on the active supervisor engine cannot be initialized. In a redundant system,
Disconnect the second uplink on the active supervisor engine.
The retimer on the active supervisor engine cannot be initialized. In a redundant system,
Disconnect the second uplink on the active supervisor engine.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
SUPERVISOR Messages
2-101