Supervisor-7; Switch-Qos-Tb Messages - Cisco Catalyst 4500 Series Message Manual

Chapter 2 Messages and Recovery Procedures

SUPERVISOR-7

Error Message C4K_SUPERVISOR-7-BACKPLANESEEPROMWRITEFAILED:Failed to write
backplane's serial eeprom
Error Message C4K_SUPERVISOR-7-SEEPROMWRITEFAILED:Failed to write supervisor's
serial eeprom

SWITCH-QOS-TB Messages

This section contains the Switch QoS Manager (SWITCH-QOS-TB) messages.
Error Message SWITCH_QOS_TB-5-TRUST_DEVICE_DETECTED: [char] detected on port [char]
Error Message SWITCH_QOS_TB-5-TRUST_DEVICE_LOST: [char] no longer detected on port
[char], port set to untrusted
OL-11541-01
The writing of the backplane serial EEPROM failed.
Explanation
Power cycle the switch.
Recommended Action
Explanation The software was unable to write to the supervisor engine serial EEPROM.
Remove and reinsert the module. If this message reappears, reboot the switch.
Recommended Action
If the switch is still unable to write to the EEPROM, contact your technical support representative.
Software detected that a device matching the trusted device boundary setting for the
Explanation
interface and changed the trust state for the interface to trusted.
Recommended Action This is an informational message only. No action is required.
Explanation The system lost contact with a trusted device and changed the trust state for the interface
to untrusted.
This is an informational message only. No action is required.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
SWITCH-QOS-TB Messages
2-103