Cisco Catalyst 4500 Series Message Manual page 36

DHCP_SNOOPING Messages
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
Recommended Action
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_DATABASE_FLASH_WARNING: Saving DHCP
snooping bindings to [char] can fill up your device causing the writes of bindings
to device
Explanation
cause the flash to fill up. Possible consequences include a long delay to regain a console connection,
write failures for database configurations, regular squeeze requirements, and reduced life of flash
due to regular squeeze operations.
Recommended Action
locations for the database agent include a TFTP or FTP server. Please see the command line help for
a complete list of options.
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_ERRDISABLE_WARNING: DHCP Snooping
received [dec] DHCP packets on interface [char]
Explanation
The interface will be placed in the errdisable state.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-16
The switch is unable to start the agent.
The Abort timer expired.
The number of entries exceeded the maximum supported limit.
An error occurred when reading the remote database.
An error occurred while writing to the remote database.
DHCP snooping expected more data during the read.
The string type is invalid.
The version string type is invalid.
DHCP snooping is expecting a new line in the database.
'TYPE' was not found in the remote database.
'VERSION' was not found in the remote database.
'BEGIN' was not found in the remote database.
'END' was not found in the remote database.
The type string was not found in the remote database.
The version string was not found in the remote database.
The checksum failed upon entry into the remote database.
Based on the reason for the error (listed above), take the appropriate action.
Saving DHCP snooping bindings to a flash file system such as bootflash or slot0 could
Save the DHCP snooping bindings to an alternate destination. Possible
DHCP snooping detected a DHCP packet rate-limit violation on the specified interface.
This is an informational message only. No action is required.
Chapter 2 Messages and Recovery Procedures
OL-11541-01