Cisco Catalyst 4500 Series Message Manual page 67

Chapter 2 Messages and Recovery Procedures
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETOVACL: Output PACL [char] is disabled
on port [char]
Explanation
the port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action
Error Message C4K_IOSINTF-5-STALEPHYPORT: Dropping packets to be transmitted out on
port [char]
Explanation
switching module is removed. This indicates such packets are being dropped.
Recommended Action
technical support representative.
Error Message C4K_IOSINTF-5-RJ45ACTIVE: Slot= [dec] Port= [dec]: RJ45 connector has
become active
Explanation
Recommended Action
Error Message C4K_IOSINTF-5-RJ45INACTIVE: Slot= [dec] Port= [dec]: RJ45 connector
has become inactive
Explanation
Recommended Action
Error Message C4K_IOSINTF-5-TXL3PKTONPHYPORT:Transmitting L3 packet on a physical
port [char] that is part of [char] ([dec] packets). Make sure the physical port
in the L3 port channel does not have an ip addresses configured on it.
Explanation
packets were sent on a physical port that is part of a bundle. This condition occurs if there is a
misconfiguration; a physical port that is part of a Layer 3 port channel might have been assigned an
IP address.
Recommended Action
IP address that is assigned to it.
OL-11541-01
If the port is configured for a VLAN that has output RACL, then the output PACL on
This is an informational message only. No action is required.
( Linecard in Slot [dec] may have been removed )
During hot-swapping operations a previously queued packet may be transmitted after a
If this message appears without any hot swapping, please contact your
A dual media port changed from using the SFP connector to using the RJ-45 connector.
This is an informational message only. No action is required.
A dual media port changed from using the RJ-45 connector to the SFP connector.
This is an informational message only. No action is required.
Layer 3 protocols operate at the logical, not the physical, port level. Layer 3 protocol
Verify that the physical interface in the Layer 3 port channel does not have an
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
IOSINTF Messages
2-47