Cisco Catalyst 4500 Series Message Manual page 72

IOSMODPORTMAN Messages
Error Message C4K_IOSMODPORTMAN-4-FANTRAYPARTIALFAILURE: A fan or thermistor/s in
system fan tray have failed
Explanation
system fan tray have failed.
Recommended Action
be immediately affected.
Error Message C4K_IOSMODPORTMAN-4-FANTRAYREMOVED:Fan tray has been removed
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-4-FANTRAYGOOD:Fan tray is okay
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-4-INLINEPOWERSUPPLYBAD: Inline power from power
supply [dec] has failed or been turned off
Explanation
a distinction between the two cases.
Recommended Action
soon as possible.
Error Message C4K_IOSMODPORTMAN-4-NFLABSENT: Netflow Services Card absent or idprom
invalid on [char] supervisor.
Explanation
installed on both the standby and active supervisor engines. Otherwise, during switchover, the
system might lose its NetFlow capabilities.
Recommended Action
Error Message C4K_IOSMODPORTMAN-4-NFLIDPROMINVALID: Netflow Services Card has
invalid idprom on [char] supervisor
Explanation
message is invalid.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-52
This is a warning message indicating that one or more fans or thermal sensors in the
Schedule a time to replace the fan tray soon. System performance should not
The fan tray was removed.
This is an informational message only. No action is required.
The fan tray passed all tests and is operating normally.
This is an informational message only. No action is required.
A PoE source from a power supply failed or was turned off. The hardware cannot make
Verify that the incoming power is good, and if it is replace the power supply as
The recommended configuration for using the NetFlow Services Card is to have it
Verify that the NetFlow Services Card is installed on both supervisor engines.
The IDPROM on the NetFlow Services Card on the supervisor engine indicated in the
Contact your technical support representative.
Chapter 2 Messages and Recovery Procedures
OL-11541-01