Cisco Catalyst 4500 Series Message Manual page 75

Chapter 2 Messages and Recovery Procedures
Error Message C4K_IOSMODPORTMAN-6-FANTRAYINSERTEDDETAILED: Fan tray ([char] S/N:
[char] Hw: [dec].[dec]) has been inserted
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-INLINEPOWEROK:Inline power within limits:Module
status changed to 'Ok'
Explanation
module.
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-MODULEINSERTED: Module [dec] is inserted
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-MODULEOFFLINE: Module [dec] is offline
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-MODULEONLINE:Module [dec] ([char] S/N:[char]
Hw:[dec].[dec]) is online
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-MODULEREMOVED: Module [dec] is removed
Explanation
Recommended Action
Error Message C4K_IOSMODPORTMAN-6-PACKETMEMORYERRORPOWERCYCLE:Supervisor power
cycled due to packet memory errors
Explanation
packet memory. It is expected that the transient SRAM errors in packet memory are cleared by a
power cycle of a supervisor engine.
Recommended Action
OL-11541-01
The fan tray was inserted.
This is an informational message only. No action is required.
The measured PoE is now below the configured value and the physical limit for the
This is an informational message only. No action is required.
A module was inserted into slot [dec].
This is an informational message only. No action is required.
The specified module is offline.
This is an informational message only. No action is required.
The specified module is online.
This is an informational message only. No action is required.
A module was removed from slot [dec].
This is an informational message only. No action is required.
This supervisor engine was power cycled to get rid of SRAM errors detected in the
Contact your technical support representative.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
IOSMODPORTMAN Messages
2-55