Switchmanager-4 - Cisco Catalyst 4500 Series Message Manual

SWITCHMANAGER Messages
Error Message C4K_SWITCHMANAGER-3-SSOHARDWAREACKTIMEOUT: Internal Event: timed out
after [dec] iterations waiting for the [char] hardware to be programmed

SWITCHMANAGER-4

Error Message C4K_SWITCHMANAGER-4-CANTPOWEROFF:Internal Error: PimEthAutoNegotiator
- Can't power off port [char]
Error Message C4K_SWITCHMANAGER-4-CANTPOWERON:Internal Error: PimEthAutoNegotiator
- Can't power on port [char]
Error Message C4K_SWITCHMANAGER-4-HARDWAREERROR:Power management hardware for port
[char] bad.
Error Message C4K_SWITCHMANAGER-4-S2WERROR:Power control to port [char] bad.
Possibly power is turned on.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-116
The active supervisor engine is taking more time than usual to program the hardware.
Explanation
This should not affect normal behavior or SSO functionality. In the worst case you may see link flaps
when the supervisor engines switch over.
This is an informational message only. No action is required. If the problem
Recommended Action
persists, contact your technical support representative.
This is an internal software error in an inline-power state machine.
Explanation
Recommended Action This is an informational message only. No action is required.
This is an internal software error in an inline-power state machine.
Explanation
This is an informational message only. No action is required.
Recommended Action
The switch cannot change the inline-power state for this port.
Explanation
Recommended Action This is an informational message only. No action is required.
This is a communication error in PoE power management.
Explanation
This is an informational message only. No action is required.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11541-01