Cisco Catalyst 4500 Series Message Manual page 131

Chapter 2 Messages and Recovery Procedures
Error Message C4K_SWITCHINGENGINEMAN-3-CIMPKTBUFPARITYERROR: Parity error in Cim
Packet Buffer at offset
Explanation
hardware problem or a more permanent problem. After 128 packet memory and queue memory
errors, the switch reboots.
Recommended Action
Error Message C4K_SWITCHINGENGINEMAN-3-ERRORINTERRUPT: Error condition detected by
hardware. Interrupt Status [hex]
Explanation
interrupt status value indicates the type of error.
Recommended Action
Error Message C4K_SWITCHINGENGINEMAN-3-FREELISTMEMORYPARITYERROR: Parity error in
freelist memory, flm addr=[hex], reg bits=[hex], total errors=%u
Explanation
transient hardware problem, or a more permanent problem leading to memory corruption. After 128
such transmit count errors, the switch will reload.
Recommended Action
for environmental conditions such as RFI or other interference. It may also be necessary to replace
the supervisor engine.
Error Message C4K_SWITCHINGENGINEMAN-3-JUMBOPACKET:Recieved a Jumbo CPU packet
Explanation
a jumbo packet.
Recommended Action
Error Message C4K_SWITCHINGENGINEMAN-3-NOMEMORYFORRXRING: Not enough memory to
initialize CPU packets
Explanation
Recommended Action
Error Message C4K_SWITCHINGENGINEMAN-3-PACKETENGINERESTARTED: An error happened in
the Packet Engine logic
Explanation
Recommended Action
OL-11541-01
[dec]
There is a parity error in queue memory. This condition might indicate a transient
If you see this message often, reboot the switch.
The hardware detected an error condition and raised an interrupt to the software. The
This is an informational message only. No action is required.
An error in freelist memory was detected. If this message persists, it may indicate a
If the switch is reloading too often due to this condition, you may need to check
The switch received a packet that is larger than 2032 bytes. This large packet is called
This is an informational message only. No action is required.
The system ran out of memory while trying to initialize the CPU packet driver.
This is an informational message only. No action is required.
The packet engine logic became unstable for unknown reasons.
Reboot the switch.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
SWITCHINGENGINEMAN Messages
2-111