Redundancy-6 - Cisco Catalyst 4500 Series Message Manual

Cisco ios system message guide
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 2
Messages and Recovery Procedures
Error Message C4K_REDUNDANCY-5-CONFIGSYNC_RATELIMIT:The [char] has been
successfully synchronized to the standby supervisor

REDUNDANCY-6

Error Message C4K_REDUNDANCY-6-ACTIVESUPNOTFOUND:Active supervisor not found.
Error Message C4K_REDUNDANCY-6-ATTEMPTINGTOBECOMEACTIVE:
Attempting to become active supervisor.
Error Message C4K_REDUNDANCY-6-DUPLEX_MODE: The peer Supervisor has been detected
Error Message C4K_REDUNDANCY-6-INIT:Initializing as [char] supervisor
Error Message C4K_REDUNDANCY-6-MODE:[char] supervisor initializing for [char] mode
OL-11541-01
The configuration was successfully synchronized to the standby supervisor engine. This
Explanation
is a rate-limited message. These messages are logged at 1-minute intervals, rather than continuously
as with many other messages.
This is an informational message only. No action is required.
Recommended Action
This message is displayed on the redundant supervisor engine when it fails to
Explanation
communicate with the active supervisor engine.
This is an informational message only. No action is required.
Recommended Action
Explanation
This message is displayed on the standby supervisor engine when it fails to
communicate with the active supervisor engine and attempts to take over as the active supervisor
engine.
Recommended Action
This is an informational message only. No action is required.
Explanation
A peer supervisor engine was detected, and the switch shifted to duplex mode.
This is an informational message only. No action is required.
Recommended Action
A supervisor engine that you are connected to is currently initializing as either the active
Explanation
or standby supervisor engine.
This is an informational message only. No action is required.
Recommended Action
The supervisor engine that you are not directly connected to is currently initializing as
Explanation
either the active or standby supervisor engine in RPR mode.
This is an informational message only. No action is required.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
REDUNDANCY Messages
2-87

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents