Storm_Control Messages; Store Messages - Cisco Catalyst 4500 Series Message Manual

STORM_CONTROL Messages

Error Message C4K_SUPERVISOR-3-SUPOCTALPHYMDIOREADERR: Failed to perform read
operation on Octal Serdes at address [dec] for the register at address [dec]
STORM_CONTROL Messages
This section contains the broadcast storm control (STORM_CONTROL) messages.
Error Message STORM_CONTROL-3-FILTERED: A [char] storm detected on [char]. A packet
filter action has been applied on the interface.
Error Message STORM_CONTROL-3-SHUTDOWN: A packet storm was detected on [char]. The
interface has been disabled.

STORE Messages

This section contains the storage (STORE) message.
Error Message C4K_STORE-2-OUTOFCHUNKS:Out of chunks of memory
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-98
There was an error with the Octal Serdes on the supervisor engine.
Explanation
Recommended Action If this continues to happen, please contact your technical support
representative to replace the supervisor engine.
The amount of traffic detected on the interface exceeded the configured threshold
Explanation
values. The system filters excess traffic when a packet is received. The system is not forwarding
packet traffic.
Determine and fix the root cause of the excessive traffic on the interface.
Recommended Action
The amount of traffic detected on the interface exceeded the configured threshold
Explanation
values. Because the interface was configured to be shut down if a packet storm event is detected, it
was placed in an errdisable state.
Recommended Action If automatic recovery is preferred, the errdisable recovery mechanism can be
used. Determine and fix the root cause of the excessive traffic on the interface.
The system has insufficient memory.
Explanation
Reboot the switch. If this message reoccurs, add additional memory.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11541-01