Cisco Catalyst 4500 Series Message Manual page 105

Chapter 2 Messages and Recovery Procedures
Error Message C4K_REDUNDANCY-3-TRANSFORM_FAIL: Redundancy ISSU client [char]
transform failed for
Explanation
transmit transformation failed, the checkpoint message was not sent to the standby device. If the
receive transformation failed, the checkpoint message was not applied on the standby device. In
both cases, the Redundancy state between the active device and the standby device is not identical.
Recommended Action
active and standby supervisor engines have software supporting ISSU. Reset the standby supervisor
engine using the redundancy reload peer command. If problems persist, contact a Cisco technical
support representative.
Error Message C4K_REDUNDANCY-3-COMMUNICATION: Communication with the peer Supervisor
has been [char]
Explanation
Recommended Action
Error Message C4K_REDUNDANCY-3-NOT_READY_FOR_SWITCHOVER: The active Supervisor
failed but standby supervisor cannot initiate
standby Supervisor.
Explanation
for the primary supervisor engine.
Recommended Action
Error Message C4K_REDUNDANCY-3-PEER_RELOAD: The peer Supervisor is being reset
because [char]
Explanation
message for the specific reason. This allows recovery from an indeterminate standby state.
Recommended Action
Error Message C4K_REDUNDANCY-3-SIMPLEX_MODE: The peer Supervisor has been lost
Explanation
Recommended Action
OL-11541-01
'Message Type [dec]'. Error: [dec] ([char])
The Redundancy ISSU client could not transform the specified message type. If the
Using the show issu compatibility matrix command, verify that both the
The status of the peer supervisor engine communication path changed.
This is an informational message only. No action is required.
The standby supervisor engine is currently in an intermediate state and cannot take over
This is an informational message only. No action is required.
The supervisor engine was reset for the reason specified by [char]. See the reported error
This is an informational message only. No action is required.
The peer supervisor engine is absent, and the switch shifted to nonredundant mode.
This is an informational message only. No action is required.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
REDUNDANCY Messages
Switchover activity. Resetting
2-85