Mitsubishi VS-5075 Owner's Manual page 93

changing the source of the PIP image
You PIP image can be used to display the picture from equipment
connected to your TV through the A!V inputs, such as a VCR. You
do this by selecting the other equipment as the "source" of the PIP
image. To select a VCR as a PIP source, fo].low these instructions.
_Important:
_Important:
oooO
°itlo u)= _
c_O OOcn
0 Turn your VCR on.
O Turn the PIP image on.
Press the SOURCE button on
the reraote control repeatedly
until the VCR picture appears
in the PIP image
If you want to selecl; a source
other than the VCR, continue
pressing the SOURCE button.
The source will change as
follows:
r j
L_TV--,Input-1--,Input-2-*lnput-3
You cannot select Antenna B as a PIP sou:rce when watching
Antenna A in the main image.
To change the source of the main image while a PIP image is
displayed, press the input button (INPUT) on the control panel or
on the remote control.
Using the Advanced Picture-in-Picture (PIP) Modes 95