Mitsubishi VS-5075 Owner's Manual page 103

Troubleshooting (cont.)
Problems Possible Solutions
For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select button
is set to "TV."
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See "Getting ready to use
the remote control" in
Chapter 1 for an explanation
of how to install batteries in
the remote control.
See "Remote control buttons
and functions" in Chapter 1,
which explains where the
select buttons are located.
See "Getting ready to use
the remote control" in
Chapter 1, which contains
pointers for using the remote
control.
The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 3, which explains
the function of the ENTER
button.
You can't access a channel.
• Be sure that the channel you
want to view is programmed
into memory.
• Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Memorizing channels"
in Chapter 3, which explains
how to program channels
into the TV's memory.
See "Selecting the input
source" in Chapter 3, which
explains how to ,change the
input source
You can't see a different
channel in the reduced PIP
image.
• Use the SOURCE button to
change the source of the PIP
image.
Make sure you haw_ a
second source, such a VCR,
turned on and connected to
your TV.
• See "Using the Advanced
Picture-in-Picture (PIP)
Modes" on page '92.
106 Chapter 5: Troubleshooting