Mitsubishi VS-5075 Owner's Manual page 36

Projection TV + VCR + cable with a cable box
(cont.)
_Important:
_Important:
O Connect the incoming cable of your cable system to the IN
terminal on the two-way splitter.
O Connect a coaxial cable to one of the OUT terminals on the
splitter; connect the other end of this cable to the ANT-A
terminal on the back of tbe Projection TV.
Connect a second coaxial cable to the other OUT terminal on
the splitter; connect the other end of this cable to the IN
terminal on the cable box.
O Connect the third coaxial cable to the OUT terminal on the
back of the cable box; connect the other end of this cable to the
ANTENNA-IN terminal on the back of the VCR.
Connect the fourth coaxial cable to the ANTENNA-OUT
terminal on the back of the VCR Connect the other end of this
cable to the ANT-B terminal on the back of the Projection TV.
O
Do ONE (not both) of the following:
• Connect a video cable to the VIDEO OUT terminal on the
back of the VCR. Connect the o_her end of this cable to a
VIDEO INPUT terminal on tlhe back of the Projection TV.
• Connect an S-video cable to t:he S-VIDEO OUT terminal on
the VCR. Connect the other _nd of this cable to an S-VIDEO
INPUT terminal on the back of the Projection TV,
Connect a set of audio cables to the AUDIO OUT terminals on
the back of the VCR. Use the red (:able to connect the right (R)
channel and the "white cable to (:onnect the left (L) channel.
Connect the other ends of these cables to the AUDIO INPUT
terminals on the back of"the Projection TV. Make sure these
terminals are in line with the terminal you used in step _.
If your VCR is monaural (non-stereo), only connect a single audio
cable. Connect this cable to the VCR, then connect the other end of
the cable to the L (LEFT) audio input on the back of the television.
If your VCR has a video channel s_itch with an "OFF/AV" setting,
set it to that setting. See your VCR's owner's guide for more details.
Start playing a tape on your VCR.
_) Use the INPUT button on the control panel or on the remote
control to select the input (INPUT-1 or INPUT-2) to which you
connected the VCR.
36 Chapter 2: Connecting Your Projection TV