Mitsubishi VS-5075 Owner's Manual page 62

_Important:
_Important:
_'Important:
Setting the A/V Network
The A/V Network is a special system that Mitsubishi developed to
make it easier to operate many products with one remote control.
When the A/V Network is connected between two Mitsubishi
products, you can point the remote control[ at one product and it
will "pass" the remote control command to the other. To set up the
A/V Network:
[] FIRST TIME SETUP
_ emorize Channels
Set the Cloc_
Add/Delete Channel
Set AN Network
Align Colors
Use these buttons on the remote:
----] ADJUST [] ENTER I_ MENU to
to select to enter go back
[] SETAN NETWORK
O AN Network: Active
When AN Network is
set to "Active" or
"Basic," your TV can
perform automated
operations with other
Mitsubishi products.
Set to "OFF" if you do not have other
Active AN Network products or are not
using an AN Network control cable.
Use these buttons on the remote:
[_ ADJUST [_ MENU to
to select go back
O Pre,_s the MENU button on the
remote control. The Main Menu
will appear on the screen.
O Use the ADJUST buttons to
select "First Time Setup." Press
the ENTER button.
Use the ADJUST tmttons to
select "Set A/V Nel;work." Press
the ENTER button.
0 Use tlhe ADJUST buttons to
select "Active," "Basic," or "Off."
Check the rear terminals of
your VCR, then use the chart
below to determine how you
should set your Projection TV.
Press the HOME button to
return to normal TV viewing.
If your VCR has a rear ..,and you have set your ...then set your
terminal that reads: VCR to: TV to:
AN Network - Basic
Active A/V Network Off Basic
Active A/V Network Active Active
Does not have an AN
Network rear terminal - Off
If you are not sure how to set )'our VCR's A/V Network setting,
refer to your VCR's owner's guide.
If connected, the A/V Network will still pass remote control signals,
even when the Projection TV's A/V Network setting is "Off."
If you have not connected the A/V Network, set "AN Network" to
"Off," or there may be problems selecting channels on your TV.
If you are using a Mitsubishi VCR with A/V Network or Active A/V
Network, you should have connected it to the INPUT-1 of your TV.
Getting Started 63