Mitsubishi VS-5075 Owner's Manual page 41

Projection TV + an amplifier with a center
channel out terminal
_>Important:
equipment you will need
To hook-up an audio system, you
will need:
• one set of RCA pin-type audio
cables.
using the Projection TV speak-
ers as center channel speakers
If you are using an amplifier that delivers Dolby Pro Lo_c* sur-
round sound (such as a Mitsubishi HTS-I00), we recommend that
you use the Projections TV's built-in speakers as center channel
speakers. A center channel speaker makes certain sounds, such as
voices, seem to come directly from the screen.
When you make this connection, the sound of your Projection TV
will be controlled by the amplifier you connected. See your
amplifier's owner's guide for more information.
O Connect the end of an RCA audio cable to the CENTER INPUT
terminal on the back of the Projection TV
O Connect the other ends of these cables to the CENTER CHAN-
NEL OUT terminals on the back of the amplifier.
O
Set the Projection TV's speakers by pressing the AUDIO button
on the control panel or the remote until you see the "Speaker:"
display. Press the ADJUST buttons to set it to "Internal center
channel." See "Adjusting the sound,':' pages 70 - 71.
Projection TV Rear Terminals
_o c Av_
e •
You should make this connection in addition to one of the other
connections in this chapter, not instead of other connections.
*"Dolby," the double-D symbol r'r], "Dolby Surround _ I l IIOOI-BYSURROUNOI, and
"Dolby Pro Logic," are trademarks of Dolby Laboral;ories Licensing Corporation.
41